null

Lectrosonics DSQD

LECTROSON

BSW PART:
DSQD

4ch Digital Wireless Receiver with Dante

$5,675.00 $7,938.00
You save $2,263.00

The DSQD Half Rack Receiver with analog and digital Dante® network audio outputs utilizes the Lectrosonics signature digital architecture with remarkable audio quality and ultra-low latency. The receiver includes an extended operating range rivaling the best analog and Digital Hybrid Wireless® systems with continuously tunable tracking filters covering 470.100 - 614.375 MHz.

The DSQD Receiver is a four-channel design with a host mainframe that contains the DSP, microprocessor, antenna multicoupler and control interface.

Antenna ports on the rear panel accept input from remote antennas, with a “loop-thru” output to another mainframe using the internal multicoupler. A kit is also available to mount antenna inputs (BNC connectors) on the front panel.

$5,675.00 $7,938.00
You save $2,263.00

Free Shipping

Out of stock

Add to quote
Qualifies for free shipping
  • Main Features:
  • Four-channel, half-rack design
  • Continuously tunable tracking filters covering 470.100 - 614.375 MHz
  • Compatible with DSW, Duet and Digital Hybrid Wireless® transmitters • Built-in wideband antenna multicoupler with loop-thru for additional receivers
  • Antenna bias power enabled from the front panel (fused and over-temperature protected)
  • IR bi-directional port for transmitter setup
  • Analog and Dante® audio outputs with TalkBack (in applicable RX modes)
  • Ethernet and USB interface
  • Offline full-system frequency coordination
  • Why Dante?
  • Plug-and-play technology – automatic discovery and simple signal routing
  • Reduced Cost & Complexity – No special skills required to set up audio networking
  • Sample accurate playback synchronization
  • Lowest latency available from any networking technology
  • Add/remove/rearrange components at will
  • Deterministic latency throughout the network
  • Support mixed bit depths and mixed sample rates over one network
  • Scalable, flexible network topology supporting a large number of senders and receivers
  • Supports 1Gbps networks • Supports a single integrated network for audio, video, control, monitoring
  • Uses inexpensive, off-the-shelf computer networking equipment
  • Specifications:
  • Operating Spectrum: 470.100 - 614.375 MHz
  • Frequency Adjustment Range: 25 kHz steps
  • Sampling Size and Rate: 24-bit, 48 kHz
  • Digital Modulation: 8PSK with Forward Error Correction
  • Data Encoding: Proprietary ADPCM
  • Encryption: AES 256-CTR (per FIPS 197 and FIPS 140-2)
  • Latency: Digital Source: 1.0 ms plus Dante network
  • Analog Source: <1.4 ms
  • Audio Performance:
  • Frequency Response: 20 Hz - 20 KHz, +\-1 dB
  • THD+N: 0.05% (1 KHz @ -10 dBFS)
  • Dynamic Range: 108 dB A-wtd, NR=NORMAL
  • Adjacent Channel Isolation: >85 dB
  • Diversity Technique: Noiseless antenna switching
  • Sensitivity: -98 dBm for 10-5 BER
  • Antenna Inputs/Outputs: Dual BNC female, 50 ohm impedance
  • Audio Outputs:
  • XLR: Balanced, -35 to +8 dBu
  • Headphone: 1/4 inch phone jack
  • Dante: RJ45
  • External DC Power: 7 to 18 VDC; 2.5A (max)
  • Weight: 1.95 lbs.; 880 grams
  • Dimensions: 8.375 x 1.75 x 7.375 in. 213 x 44.5 x 187 mm