- Main Features:
- High-precision drivers, Mathematically Modelled Dispersion™ (MMD™) waveguide
- Linear frequency response 39 Hz … 21 kHz (±3 dB)
- Linear phase response 105 Hz … 16 kHz (± 45°) with latency < 2,6 ms
- DSP engine allows for room adaptive calibration via Neumann’s MA 1
- Razor-sharp imaging due to extremely low tolerances (± 0.8 dB)
- May be combined with other KH line speakers in immersive/surround setups
- Specifications:
- Free field frequency response ±6 dB: 36 Hz ... 21 kHz
- Free field frequency response ±3 dB: 39 Hz ... 20.4 kHz
- Pass band free field frequency response: 42 Hz … 20 kHz, ±1.25 dB
- Free field frequency linearity deviation between 100 Hz and 10 kHz: ±0.8 dB
- Self-generated noise at 10 cm (with input gain set to 100 dB SPL for 0 dBu): <20 dB(A) SPL
- Sine wave output with a THD < 0.5 % at 1 m in half space: 95 dB SPL (>75 Hz)
- Max. SPL calc. in half space at 3% THD at 1m (averaged between 100 Hz and 6 kHz): 118.7 dB SPL
- Max. SPL in full space at 3% THD at 1m (averaged between 100 Hz and 6 kHz): 112.7 dB SPL
- Bass capability: Max. SPL in half space at 3% THD at 1m (averaged between 50 Hz and 100 Hz): 107.5 dB SPL
- Max. short term SPL with IEC-weighted noise (IEC 60268-5) at 1 m, in typical listening conditions: 108 dB(C) SPL
- Max. short term SPL with music material at 2.3 m in typical listening conditions (pair / full range): 100 dB(C) SPL
- Max. short term SPL with music material at 2.3 m, in typical listening conditions (pair with subwoofer): 106 dB(C) SPL
- Max. long term SPL with pink noise at 2.3 m, in typical listening conditions (single / pair full range): 88 / 94 dB(C) SPL
- Max. long term SPL with pink noise at 2.3 m, in typical listening conditions (single / pair with subwoofer): 88 / 94 dB(C) SPL
- Dolby D.A.R.D.T. Max SPL fullrange: 114 dB
- Dolby D.A.R.D.T. Max SPL bass managed: 120 dB
- Recommended Listening Distance: 1.0 … 2.5 m; (3'… 8')
- Feasible Listening Distance: 0.75 … 6.0 m; (2'6"… 18')
- Acoustic principle: Bassreflex, Ports at the front
- Analog input(s): XLR: analog electronically balanced
- Analog input impedance: 24 kOhms
- Max. input level:
- +24 dBu for 94 dB SPL setting
- +14 dBu for 100 dB SPL setting
- +9 dBu for 108 dB SPL setting
- -1 dBu for 114 dB SPL setting
- Common mode rejection ratio (CMRR): >56 dB @ 15kHz
- Volume control: via MA 1 software
- Volume control range; resolution: 0 … -∞ dB; 0.1 dB
- Analog dynamic range; THD+N: 118 dB, A-weighted, 90 dB
- Signal routing modes: analog, S/PDIF L, S/PDIF R, S/PDIF mono
- Digital input(s): RCA (75 Ω): S/PDIF
- Digital output(s): RCA (75 Ω): S/PDIF
- Max. Input Level; pk-pk, unbalanced / balanced: 1.2 V
- Digital converter: resolution; design: 24 Bit
- Digital converter: sampling rate: 32 kHz..200 kHz
- Digital internal sampling rate: 48 kHz
- Output sample rate: identical to input sample rate
- Latency ADA / DA:
- Analog Input: 2.6 ms; SPDIF
- Input: 2.1 ms
- Delay: User adjustable delay range: 0 … 120 ms
- Delay: Resolution: time; distance: 20.8 µs
- Delay: Max. frames Audio-video synchronisation (lip sync): 0 … 120 ms for TOF=0ms, depends on APP implementation
- Delay: Time-of-flight maximum distance: 0 … 120 ms for lipsync=0ms, depends on APP implmentation
- Transport/storage conditions: -25° C to +60° C (-13° F to 140° F); <90% RH; non-condensing
- Input gain control (sensitivity): 0 dB ... -15 dB
- Output level control (output level in 1 m based on 0 dBu input level): 94; 100; 108; 114 dB SPL
- Equalization: Bass: 0; -2; -4; -6 dB
- Equalization: Low-Mid: 0; -2; -4; -6 dB
- Equalization: Treble: +1; 0; -1; -2 dB
- Input selector: Analog; S/PDIF L; S/PDIF R; Mono
- Ground Lift: Yes
- Control: Local; Network
- Mains Switch: Yes
- Mains Voltage Select: Universal Power Supply 100 V~ … 240 V~
- Controller design: Digital; active
- Crossover frequency: 1700 Hz
- Crossover slope: 48 dB / octave
- Equalization: via Neumann.Control software: No
- Automatic room calibration via MA 1: Yes
- FIR phase correction: Linear phase (105 Hz ... 16 kHz; +/- 45°)
- Protection circuitry: Independent soft clip, peak and thermo limiters for woofer and tweeter; Woofer excursion limiter; thermo limiter for the electronics and amplifiers
- Infrasonic filter: frequency; slope: 38 Hz; 12 dB / octave
- Remote control: MA 1 software via an RJ45 connector carrying standard IP data
- Display: On; Normal Operation: Neumann logo “White”
- Display: Identification: Neumann logo “Rosé”
- Display: Limit / Clip / Errors / Protection /Boot Mute / Shut Down Mute: Neumann logo “Red”
- Logo Brightness: via MA 1 software
- Output power woofer amplifier (THD+N with limiter deactivated: 10%): 145 W
- Output power tweeter amplifier (THD+N with limiter deactivated: 10%): 100 W
- Output power woofer amplifier (THD+N with limiter deactivated: 0.1%): 120 W
- Output power tweeter amplifier (THD+N with limiter deactivated: 0.1%): 80 W
- Mains Power Supply: input voltage; frequency: 100-240 V; 50/60 Hz
- Power consumption (230 V / 100 V): Standby: 0.3 W
- Power consumption (230 V / 100 V): Idle: 15 W
- Power consumption (230 V / 100 V): Full output: 320 W
- In-rush current (Peak): 33 A
- Standby: automatic, 90 mins (default); user defined in software
- Cabinet material: Composite polycarbonate front and rear, wooden sleeve
- Cabinet surface finish; color (front / back): Painted; metallic anthracite (RAL 7021) / Black (RAL 9005)
- Operating conditions: +10° C to +40° C (+50° F to +104° F); <75% RH, non-condensing
- Woofer: 165 mm; (6.5") with protecting black metal grille
- Tweeter: 25 mm; (1") with protecting black metal grille
- Mounting points: 2 x M6 threaded inserts with 70 mm spacing on back panel; thread depth 15 mm; (5/8”)
- Product dimensions (height x width x depth): 345 x 225 x 273 mm; (13.58" x 8.86" x 10.75")
- Internal net volume: 12.6 l
- External net volume: 20.4 l
- Packed dimensions (height x width x depth), mm (inches): 480 x 303 x 403 mm; (18.9" x 11.9" x 15.9")
- Product weight: 8.0 kg; (17 lbs 10 oz)
- Packed weight: 9.4 kg; (20 lbs 12 oz)
- Packaging weight inc. Cables and manuals: 1.41 kg; (3 lbs)
- Packed cube: 0.059 m³; (2.08 ft³)
