- Main Features:
- Selectable output power to maximize battery life or operating range
- Machined aluminum, corrosion resistant housing
- Water resistant seals for use in wet environments
- LCD interface with lockout option
- Programmable compatibility modes for use with a wide variety of different receivers
- Servo Bias input circuitry with selectable voltage
- Specifications:
- Channel Spacing: 100 kHz
- Frequency selection: Control panel mounted membrane switches
- RF Power output: Switchable; 50, 100 or 250 mW
- Compatibility Modes (6) Digital Hybrid Wireless® (400 Series), 200 Series, 100 Series, Mode 3, Mode 6, IFB
- Pilot tone: 25 to 32 kHz; 5 kHz deviation (in 400 Series Hybrid Mode)
- Frequency stability: ± 0.002%
- Deviation: ± 75 kHz max. (in 400 Series Mode)
- Spurious radiation: 60 dB below carrier
- Equivalent input noise: –125 dBV, A-weighted
- Input level:
- Dynamic mic: 0.5 mV to 50 mV before limiting. Greater than 1 V with limiting.
- Electret lavaliere mic: 1.7 uA to 170 uA before limiting. Greater than 5000 uA (5 mA) with limiting.
- Line level input: 17 mV to 1.7 V before limiting. Greater than 5 V with limiting.
- Input impedance:
- Dynamic mic: 300 Ohms
- Electret lavaliere: Input is virtual ground with servo adjusted constant current bias
- Line level: > 2.7 k Ohms
- Input limiter: Soft limiter, 30 dB range
- Bias voltages: Selectable; 2V, 4V and Off
- Gain control range: 44 dB; panel mounted membrane switches
- Modulation indicators: Dual bicolor LEDs indicate modulation of –20, -10, 0, +10 dB referenced to full modulation
- Controls: Control panel with LCD and four membrane switches
