Wheatstone LX-CR

This module is for Control Room monitor mix control and Source Selection for input channels, monitor mixes and switched meters.

SEND 1

Level Control When an input channel is in SET mode, this knob controls the level of that channel into the SEND 1 mix. There is an associated LED indicator ring in the meterbridge to display this level. Pressing the knob turns the Send ON or OFF.

STEP Button

Steps through the channel MODEs (Mono, Left, Right, Stereo).

SOURCE Selector 8-Character Display

When an input, monitor, or switched meter is in SET mode, this display shows the available sources as the encoder is scrolled.

SOURCE SELECT Encoder

When an input, monitor, or switched meter is in SET mode, this encoder is used to scroll through the list of available sources. Once the encoder is turned, the TAKE button lights up. Holding the SET button down while turning this knob sets channel input gain.

TAKE Button for Source Select

When the desired source shows in the display, press to connect the source (times out after 20 seconds). CR/HDPN Monitor Source 8-Character Display Shows the active source for the control room and headphone monitor mix.

EXT Button for Control Room/ Headphone Monitor

A programmable “wild” source hot button for the control room and headphone monitor mixes. Press the EXT button to choose this wild source; press and hold to program the button.

SET Button for Control Room/ Headphone Source Selection

Press to enter SET mode for the control room/headphone mix and select the desired source.

SOURCE Selection Buttons

Pressing one of these places a console output bus into the control room / headphone monitor mix. More than one bus can be selected, and all selected sources will be mixed together.

FADER

100 mm long-throw professional fader sets the control room monitor mix level.