JK Audio RemoteAmp

The RemoteAmp is a simple battery-powered personal headphone amplifier.

Use the RemoteAmp as an IFB earpiece or headphone amplifier, or as an on-stage monitor headphone amplifier. This low-distortion, 1 watt amplifier will cut through the crowd noise without distortion.

The RemoteAmp clips to your belt and accepts a 3-pin XLR audio input from a mixer, distribution amplifier, telephone line hybrid, or a handset interface like our QuickTap IFB. You'll like the convenience features, such as the separate power switch, which allows you to leave the volume control set at a comfortable level.

Cut through the Crowd Noise. The RemoteAmp is a simple battery-powered personal headphone amplifier. Use the RemoteAmp as an IFB earpiece or headphone amplifier, or as an on-stage monitor headphone amplifier. This low-distortion, 1 watt amplifier will cut through the crowd noise without distortion.

Volume Under Control. The RemoteAmp clips to your belt and accepts a 3-pin XLR audio input from a mixer, distribution amplifier, telephone line hybrid, or a handset interface like our QuickTap IFB. You’ll like the convenience features, such as the separate power switch, which allows you to leave the volume control set at a comfortable level.

• XLR Line level Input

• XLR Line In Volume Control

• 1/4" Stereo Headphone Jack

• 1/8" (3.5mm) Earpiece Jack

• Stainless Steel Belt Clip

• 20 Hours on one 9V Battery

• Female XLR: 4k ohms 100 mV RMS (-18 dBu nom, +12 dBu max)

• Max Gain: 46 dB

• Line Output 1/4” Mono/Stereo: 8 ohms, 1 Watt max 1/8” (3.5mm) Mono: 150 ohms, 100 mW nom.

• Frequency Response: 30 Hz - 20 kHz ± 1 dB

• Power: One 9 volt Alkaline Battery

• Size: 5.1” x 2.7” x 1.3” (13 x 6.9 x 3.3 cm)

• Weight: 10 oz. (275 g)